Used for protecting aluminium or steel posts against chafing or electrolysis with stainless balustrade wire. Black grommets enhance the appearance ...View full details
Max Run Length
- System A
- System B
- System C
- System D
- System E
- System F
- System G
- System H
- System I
- System J
- System K
- System K2
- System L
- System M
- System S
Works with Stairs?
System S - Factory Swaged DIY Balustrade Wires for Metal Posts
The Blind Rivet Nut with Swaged Stud Slimline Balustrade System is an elegant looking stainless steel balustrade, with the tensioning mechanism inside the metal anchor posts.
Enter the total number of System S wires required and add to cart. By using Quickshop, you can add the things you need without leaving this page.
Calculate the total length in whole metres of wire rope required (number of wires per run x total length of all runs).
Add Blind Rivet Nuts if required for fitting to your existing metal posts (BRN's are included in the posts if you purchase new posts from us). You'll need a left hand thread BRN and a right hand thread BRN for terminating each wire into the posts.
If you have stairs runs, add 1 x SWCP LHT and 1 x SWCP RHT for each wire in each stair run.
Add any other accessories you need (eg Blind Rivet Nut Tool).
You'll need to send us a separate email with your required run lengths, for example:
3250 x 11, 4146 x 11, 2545 x 10 + SWCP - which means:
11 wires @ 3250mm, 11 wires @ 4146mm, and 10 wires for stairs @ 2545mm including swivel connectors.
Note all measurements should be inside post to inside post, with stairs measured the same way but parallel to the handrail.
Used for protecting aluminium or steel posts against chafing or electrolysis with stainless balustrade wire. Installation for angled grommets requi...View full details