System K2 - Factory Swaged Rigging Screw (x2) Slimline Balustrade System

System K2 - Factory Swaged Rigging Screw (x2) Slimline Balustrade System

The Rigging Screw x2 Slimline Balustrade System is an elegant looking stainless steel balustrade with an external slimline tensioner fitted to each end of the wires.  This system is designed for fitting to timber posts via included Lag Eye Screws. Alternately, this system can be fitted to metal posts via Small Eye Screws fitted into Blind Rivet Nuts installed into the metal posts.

Enter the total number of System K2 wires required and add to cart.  By using Quickshop, you can add the things you need without leaving this page.

Calculate the total length in whole metres of wire rope required (number of wires per run x total length of all runs).

Add any other accessories you need (eg lag screw driver tool and rigging screw spanner).

You'll need to send us a separate email with your required run lengths, for example:

3250 x 11, 4146 x 11, 2545 x 11 - which means:

11 wires @ 3250mm, 11 wires @ 4146mm, and 11 wires @ 2545mm

Note all measurements should be inside post to inside post, with stairs measured the same way but parallel to the handrail.

Installation is the same as for System K, except that there is a rigging screw at both ends instead of a single rigging screw and fork terminal.

Balustrade System K2 - Balustrade Wires with 2 x Rigging Screws

Balustrade System K2 - Balustrade Wires with 2 x Rigging Screws

$19.50

The Rigging Screw and Fork Terminal Slimline Balustrade System (System K2) is used with our most popular (system K) balustrade kit, where there are...

View full details
$19.50

You recently viewed

Clear recently viewed