System H - Factory Swaged DIY Balustrade Wires for Timber Posts

System H - Factory Swaged DIY Balustrade Wires for Timber Posts

The Timber Insert with Swaged Stud Slimline Balustrade System is an elegant looking stainless steel balustrade with the tensioning mechanism inside the anchor posts.

Enter the total number of System H wires required and add to cart.  By using Quickshop, you can add the things you need without leaving this page.

Calculate the total length in whole metres of wire rope required (number of wires per run x total length of all runs).

If you have stairs runs, add 1 x SWCP LHT and 1 x SWCP RHT for each wire in each stair run.

Add any other accessories you need (eg driver tool).

You'll need to send us a separate email with your required run lengths, for example:

3250 x 11, 4146 x 11, 2545 x 10 + SWCP - which means:

11 wires @ 3250mm, 11 wires @ 4146mm, and 10 wires for stairs @ 2545mm including swivel connectors.

Note all measurements should be inside post to inside post, with stairs measured the same way but parallel to the handrail.

Installation Instructions

3.2mm S316 Stainless Rope 1 x 19 Construction - cut length per metre

3.2mm S316 Stainless Rope 1 x 19 Construction - cut length per metre

$1.44

AISI 316 (marine grade) stainless steel premium quality wire rope. Made with diamond coated dies and heat annealed, this stainless steel cable is e...

View full details
$1.44
Nylon Grommet Split Type, Black, 9mm O.D. x 10mm long, suits wire rope 3.2-5.0mm

Nylon Grommet Split Type, Black, 9mm O.D. x 10mm long, suits wire rope 3.2-5.0mm

$0.54

Used for protecting aluminium or steel posts against chafing or electrolysis with stainless balustrade wire. Black grommets enhance the appearance ...

View full details
$0.54

You recently viewed

Clear recently viewed