The Lag Screw Swage Stud Slimline Balustrade System (System L) is a low cost and simple stainless wire balustrade kit. The stainless steel fittings...View full details
Max Run Length
- System A
- System B
- System C
- System D
- System E
- System F
- System G
- System H
- System I
- System J
- System K
- System K2
- System L
- System M
- System S
Works with Stairs?
System L - Factory Swaged DIY Balustrade Wires for Timber Posts
The Swaged Lag Screw Terminal Slimline Balustrade System is an elegant looking stainless steel balustrade with the tensioning mechanism inside the anchor posts.
Enter the total number of System L wires required and add to cart. By using Quickshop, you can add the things you need without leaving this page.
Calculate the total length in whole metres of wire rope required (number of wires per run x total length of all runs).
If you have stairs runs, add 1 x SWCP LHT and 1 x SWCP RHT for each wire in each stair run.
Add any other accessories you need (eg lag screw terminal spanner).
You'll need to send us a separate email with your required run lengths, for example:
3250 x 11, 4146 x 11, 2545 x 11 - which means:
11 wires @ 3250mm, 11 wires @ 4146mm, and 11 wires @ 2545mm.
Note all measurements should be inside post to inside post, with stairs measured the same way but parallel to the handrail.
Please note that System L is unsuitable for angled stair runs, we recommend System H with swivel connectors, or System K for this application.